LG STUDIO LSSG3017ST Owner's Manual download pdf (Page 16)

INSTALLATION

Installing the Anti-tip Device

Anti-tip

bracket

Wall plate

Screw must

enter wood or

concrete

The anti-tip bracket is packaged with an installation

template. The instructions include necessary

information to complete the installation. Read and

follow the range installation instruction sheet.

WARNING

•

Range must be secured with an approved anti-tip

device.

•

The range could be tipped by standing, sitting or

leaning on an open door if the range or anti-tip

device is not properly installed.

•

After installing the anti-tip device, verify that it is in

place by carefully attempting to tilt the range forward.

•

This range has been designed to meet all recognized

industry tip standards for all normal conditions.

•

The installation of the anti-tip device must meet all

local codes for securing the appliance.

•

The use of this device does not preclude tipping of

the range when not properly installed.

•

A child or adult can tip the range and be killed.

•

Install the anti-tip device to the structure and/or the

range. Verify the anti-tip device has been properly

installed and engaged by following the guide of the

Anti tip bracket template.

•

Engage the range to the anti-tip device by following

the guide of the Anti tip bracket template. Ensure

the anti-tip device is re-engaged when the range is

moved by following the guide of the Anti tip bracket

template.

•

Re-engage the anti-tip device if the range is

moved. Do not operate the range without the anti-

tip device in place and engaged.

•

See installation instructions for details.

•

Failure to do so can result in death or serious

burns to children or adults.

Optional Rear Filler

If the counter does not bridge the opening at the rear

wall the rear filler kit, that is provided with the slide in

range, will be needed.

NOTE

If the countertop depth is greater than 25" there will

be a gap between the filler kit and the back wall.

If the countertop depth is less than 24", the control

panel will not sit flush with the countertop.

Installing the Rear Filler

Using a screwdriver, remove the three screws

holding the rear bracket in place.

Rear bracket

Attach the rear bracket and filler assembly as

shown, using the three screws removed in

step 1.

Rear ller

Providing Adequate Gas

Supply

Your range is designed to operate at a pressure of

5" of water column on natural gas or 10" of water

column on LP.

Make sure you are supplying your range with the type

of gas for which it is configured.

This range is convertible for use on natural or LP gas.

When using this range on LP gas, conversion must

be made by a qualified LP installer before attempting

to operate the range.

For proper operation, the pressure of natural gas

supplied to the regulator must be between 5" and 13"

of water column.

For LP gas, the pressure supplied to the regulator

must be between 10" and 13" of water column. When

checking for correct operation of the regulator, the

inlet pressure must be at least 1" more than the

operating (manifold) pressure as given above.

The pressure regulator located at the inlet of the

range must remain in the supply line regardless of

which type of gas is being used.

A flexible metal appliance connector used to connect

the range to the gas supply line should have an I.D.

" and a maximum length of 5 feet. In Canada,

flexible connectors must be single wall metal

connectors less than 6 feet in length.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 131 132

Comments to this Manuals

No comments

LG STUDIO LSSG3017ST Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Cookers LG STUDIO LSSG3017ST